Avalon H Series Manual de Serviço descarregar pdf (Página 178)

Installation Instructions for 45HW & 47HW Electrified Mortise Locks

BEST ACCESS SYSTEMS

a Division of Stanley Security Solutions, Inc.

Configuring & installing the mortise case

9 Rotate latchbolt (if necessary)

1 Determine whether you need to rotate the latchbolt to

match the handing of the door.

Note: The angled surface of the latchbolt must contact

the strike when the door closes.

2 If you need to rotate the latchbolt, insert a flat blade

screwdriver into the latch access point approximately

1/2″ into the case and press to extend the latch out of

the case (Figure 9).

3 Rotate the latchbolt 180 degrees and allow it to retract

into the case.

10 Position hub toggles (if necessary)

1 Check whether the hub toggles are in the proper

position for the lock (Figure 10). The inside hub toggle

should be down (always latched) and the outside hub

toggle should be up (lockable).

Note 1: For LH & LHRB doors, the inside is the back side

of the case and the outside is the cover side of the case.

For RH & RHRB doors, the inside is the cover side of the

case and the outside is the back side of the case. The

cover is mounted to the case with 4 screws.

Note 2: If the lock has an optional RQE status sensor,

two RQE status switches are installed in the mortise case.

However, only the switch for the inside of the lock needs

to be connected. Before you install the mortise case in the

door, determine whether you need to connect the ‘Case

Side’ pair of RQE wires or the ‘Cover Side’ pair of RQE

wires, based on the handing of the door.

2 To change the position of a hub toggle, remove the

toggle screw, move the toggle into the desired

position, and re-tighten the screw.

Figure 9 Rotating the latchbolt

Latch access point

Figure 10 Positioning the hub toggles

Hub toggleHub toggle

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 195 196

Sem comentários

Avalon H Series Manual de Serviço Página 178